The program chart is written in in the dispenser assy so it's easy to select the program.
Three switches meant for water plus, Spin Cancel and Spin speed provided/
Program selector switch(Timer)
Off/On and different temperature settings are provided. (A Single switch). i.e the temperature switch itself acts as on/off switch.It's different positions are as follows
0- OFF
1-ON
30- 60 degree- ON & respective temperature
The following figure shows the dispenser assy. I is meant for Prewash; II for main wash; the flower symbol represents the additives to be added for rinsing(Like softener). Here one important thing should be noted. Only if we select the program from prewash, then we've to put detergent in the prewash compartment. Otherwise, Put the detergent in the main wash compartment alone. Softener should be added in the rinsing compartment at the beginning of the program itself. The machine will automatically take the softener at the time of rinsing
Three switches are provided for water plus, No Spin and Spin Speed respectively.
1.Water Plus: If we want to rinse the clothes with more water.
2.No Spin: If we don't want Spin- to get the clothes wrinkles free.If we press this switch, the spin will not go on, so the clothes will be wet only.
3.Spin Speed: By Pressing this switch the spin speed in reduced to 600 rpm instead of 800 rpm. Now, the Spin will go on, but less effective.
The above two diagrams show the on/off switch and program switch respectively. The third diagram shows the options available in program switch for understanding purpose..
The program switch consists of two major cycle.1.A to H.(Normal and Heavy Cycle). 2.G to L(Gentle and Delicate Cycle)
Procedure:
1.Open the tap.
2.Load the clothes
3.Close the door
4. Put the detergent in main wash compartment(II).Put the detergent in Prewash(I) Compartment also if you start the cycle from 'A' or 'G'.
5.Select the program between A to D for normal cycle and G to K for delicate cycle.(The difference between B,C and D is only wash timing; If you keep it in 'A', Prewash will take place first, then water will drain and then it moves to B(main wash); Likewise For delicate cycle- with prewash-G;Main wash H and K)
6.Turn On Temperature Switch from 0 to 1(ON) and set the temperature if required.
7.The Entire program will go on and the machine turns off. When the programing takes place, Green Light(LED) will be On. When It turns off, the green light goes OFF and the red light turns ON.
Precautions:
1. Ensure that the door is closed properly.
2. When the program takes place, the door gets locked and don't try to open in between.
3.After the program is over it takes 60 to 90 seconds for the lock to release. Don't try to open the door till then.